I have an older 2900 (ST: <REMOVED>) that had a power failure last night. Since then it won't initialize the drives. Error is:
F/W us in Fault State
Adaptor at Baseport FC48h is not responding
No Adaptor
Steps Taken:
1. I've reseated adaptor
2. disconnected battery/held power button in 20 secs
3. moved drives from one cage to another
4. removed each drive one at a time and tried boot
5. moved cables around/tried different port on controller
The only thing that seems to make any difference is if I disconnect all the drives at the same time and then I get the messages about "none of your drives in the configuration are present".
Please advise - I very much appreciate your time in advance.