Hope this newbie can get some help here!
our poweredge 1800 Raid controller Perc4/dc failed last week.
i installed the exact same controller D9205 and rebooted.
I can now only get this to boot up if I disable the Primary scsi controller and the embedded sata controller. at which point the system boots up just fine with all system go except for the PowerVault
100T dat72 tape drive. when i check under storage controll, libaries it has a red circle and a white x beside it.
If I reboot and go into setup and change either or both the primary scsi controller and the embedded sata controller, then the system blinks a red light and will not boot up.
i believe there is some type of configuration error in the bois but not sure? maybe IRQ ASSIGNMENT.
any feed back is more than welcome!!