PE T110II RAID-1 Degraded, The Only Drive in RAID Volume Has Bad Blocks
Drive0 has bad blocks, Drive1 completely failed (missing). I replaced Drive1 and added the new drive as a hot spare and the RAID is in the process of rebuilding. I have a 2nd new drive I was going to add as a hot spare (Drive3) and once the current RAID status is Optimal, take Drive0 offline from Open Manage (remotely) and rebuild the RAID again with the 2nd hot spare. Is this possible and should I go this route or would it be better to replace Drive0, rebuild the RAID-1 from scratch with both new drives and restore from backup? My issue with restoring from backup is I tried a restore last week but I was getting an error message in Symantec System Recovery 2013 when attempting to restore the boot and system partition.