Poweredge R410 without case, HDD, fans.
Hello,I have a motherboard with 24GB RAM, 2X XEON, 2X PSU, 2x fans, and front panel.When I push the power button the id led starts blinking orange.What can I do to start the system?Thank.
View ArticleServer BIOS update Hung R620
I am trying to perform a BIOS update via iDRAC Virtual Media, have done this many times, and the process is hung. It notes Updating from 2.4.3 to 2.5.2 Server is R620 Still under warrantyIt warns not...
View ArticleLooking to Upgrade - How to Check Compatibility?
I need to change the hw configuration of my poweredge, but I am not sure what I's to do and T's to cross.I have a C2100 that appears to have some nonstandard hardware in it. Most notably, the...
View ArticleDell UPS ULNM Graceful Shutdown settings
From the manual, it looks like we can only set the graceful shutdown of the server by timing in seconds. I want to know if it is possible to set the graceful shutdown by battery percentage left on the...
View ArticleR730XD H730P - F/W in in Fault State
When booting up, I get the following message from the PERC Controller:F/W is in Fault State - MFI Register State 0xF0010000Adapter at Baseport is not respondingNo AdapterWe use a bunch of SSD's.Any...
View ArticlePoweredge 2900 - 2 hard disk failed - just 1 change. I can rebuild with still...
Poweredge 2900 - 2 hard disk failed - just 1 change. I can rebuild with still 1 failed ?i join Dell_DSET log but i can't full update result.best regardMorais Lino
View ArticleDell R320 Getting Slow - No recovery until power-off - unplug -> The speed...
HI All,we are experiencing a R320 server getting extremely slow after using it for few days. Symptoms are that the CPU goes to fixed use of 10-15% and everything becomes very slow almost unusable. Even...
View ArticlePower Edge T410 Won't boot
Pushing the start button will not start the unit. On the back of the system, there is a red button. If I press it the server begins to start. Has anyone seen this?John
View ArticleT320 w/iDrac7 keep loosing my fan speed on power downs and idrac resets
I've got a T320 (Firmware up to date on everything) with 8 drives. I've found I need to set the fan (Thermal) to "override/ low" setting in order to keep the drives from getting too warm. High...
View ArticleNeed Windows web server 2008
Not R2. I have the license key just not the media. Called Dell and they do not have any solution unless I renew support. There is a Recovery Partition, I just can not find how to use it. I have...
View ArticlePoweredge R410 without case, HDD, fans.
Hello,I have a motherboard with 24GB RAM, 2X XEON, 2X PSU, 2x fans, and front panel.When I push the power button the id led starts blinking orange.What can I do to start the system?Thank.
View ArticleRAC0503 and RAC0501 with T620 and H310
I have a T620 with one Perc H310 connected to the backplane. In the iDrac when I go to storage I get the following error:RAC0501: There are no physical disks to be displayed. 1. Check if the host...
View ArticlePERC 100 - Drives not listed
Hello all,Sorry if this was answered somewhere, I couldn't find it. I was given an old Dell PowerEdge R310 and asked to spin it up for some testing. I wanted to set it up with a Raid 5, so I threw in...
View ArticleBCM5720 Firmware upgrade 7.8.16 to 7.10.64 fails
PowerEdge 720BCM5720 Firmware upgrade 7.8.16 to 7.10.64 fails The upgrade worked for two of four interfaces. I have attempted several things but I just can’t get off 7.8.16 on the other two. Every...
View ArticleProblem(s) occurred after updating the firmware of iDRAC, Controller for...
Hi there,We have a single unit r720xd server and it has been extremely noisy since we purchased it.A couple days ago I updated the firmware of iDRAC and controller and BOIS then the system became...
View ArticlePowerEdge VRTX Disk Requirements
Hi Guys,I know the traditional Dell SANs only allow Dell HDD, the requirements for each SAN typically list the model numbers of the drives it supports. I need to buy some new drives for my PowerEdge...
View ArticleDell R710 AC v DC power supply and Regulatory Issues
I have a Dell R710 AC server and would like to swap it out with an Dell R710 DC power supply.Yet I've seen both AC and DC versions of R710 systems. Can one swap the AC supply and DC supply and will the...
View ArticlePowerEdge T610 won't power up.
I am assuming the power switch is bad. Power Supplies light up green. Power indicator light on the motherboard lights up green. Case is closed and front display that show's any errors is clear....
View ArticleCPU0000 CPU1 internal error (IERR) contact support - PowerEdge T320
Yesterday we had one of our servers go down and after it was displaying this error (seen in title). It hasn't crashed since but I've been unable to find a cause. I checked the event logs and nothing...
View ArticleDRAC not accessible after switching off Auto Negotiation
Hi,I am on a PowderEdge1950 with a DRAC5. I switched off Autonegotiation and now the web-interface is not loading anymore (timeout). racadm is not available on my server.What can I do (except to drive...
View Article