Good Day and HNY to all
I am running a ms 2008 64 bit on a PowerEdge R710 Dell Server
After an electricity shut down , during the boot i get this message
IDRAC6 not responding. Power required may exceed PSU wattage
Press F1 key to continue, f2 to run system setup program
There is a "How to resolve note " , but i cannot boot to iDRAC BIOS because , no message Ctrl+E is displayed . So, i try to press many times during the boot Ctrl+E and the system is not responding at to the command . Moreover the funs are running on high mode, which is not odd according to this issue . The ex system adminitrator did not provide me any setting of IDRAC, including ip, webport, username or password and i am unable to access it via web
Any help will be appreciate. I am really stuck there
Ty
Dimi
↧
Idrac6 PowerEdge R710
↧